A practical reference on HPLC assay: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-01-27. Anything still debated is marked as such rather than presented as settled.
In dry solid form, creatine monohydrate is relatively stable when protected from moisture and heat. The crystal lattice includes water, and exposure to high humidity can cause caking or gradual changes in powder flow. Elevated temperatures may accelerate decomposition, particularly if moisture is present. Studies generally report that sealed, dry material retains acceptable purity for extended periods, although exact shelf life depends on packaging and storage conditions. Light exposure is not usually considered a major factor for this compound.
In aqueous solution, creatine monohydrate undergoes a slow conversion to creatinine, a cyclized degradation product. This reaction is pH- and temperature-dependent, and it proceeds faster in warm or alkaline conditions. Because the conversion is gradual, analytical measurements of creatine in solution must account for time and storage history. The equilibrium favors creatinine more strongly at higher temperatures, which is relevant to sample handling in laboratories and to beverage formulations. Refrigeration slows but does not entirely stop this process.
Quality assessment of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Other methods include nuclear magnetic resonance spectroscopy, titration, and infrared spectroscopy for identity confirmation. Purity is often reported as a percentage of the labeled compound on a dry basis, while moisture content is measured separately. Because different analytical methods have different selectivity, comparing purity values across sources requires attention to the method and sample preparation.
Analytical methods for creatine monohydrate focus on identity, purity, and degradation products. High-performance liquid chromatography with ultraviolet detection is common, often at a wavelength near 210 nanometers. Titration and nuclear magnetic resonance spectroscopy can also quantify the parent compound. Pharmacopeial monographs specify tests for appearance, solubility, water content, and related substances, including creatinine. Purity values above 99 percent are typical for pharmaceutical-grade material, though supplement-grade products vary. Independent verification can detect label discrepancies.
Sourcing and verification of creatine monohydrate involve both manufacturing origin and third-party testing. Industrial production commonly starts with sarcosine and cyanamide, followed by crystallization to obtain the monohydrate. Some products are derived from animal sources, while others are synthesized from non-animal precursors. Certificates of analysis report assay, heavy metals, and microbial limits. Regulations differ by country: in the United States it is sold as a dietary supplement, whereas in the European Union it falls under food supplement rules.
In solid form, creatine monohydrate is relatively stable when kept dry and away from heat. Moisture and elevated temperatures promote cyclization into creatinine, a related compound with no role in the phosphagen system. Degradation accelerates in aqueous solution, where the conversion can occur within hours to days depending on pH and temperature. Manufacturers typically recommend storage in sealed containers at room temperature, with relative humidity below 50 percent. Long-term stability data for opened containers are limited.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Cool, dry, sealed container; avoid heat |
| Relative humidity | Low; keep below about 60% | Moisture promotes caking and degradation |
| Primary degradation product | Creatinine | Forms by cyclization, especially in solution |
| Common assay method | HPLC with UV or RI detection | Separates creatine from creatinine and related impurities |
| Moisture content | Typically reported as percentage | Measured by Karl Fischer titration or loss on drying |
Commercial creatine monohydrate is typically manufactured through chemical synthesis, often starting from sarcosine and cyanamide. The resulting material is crystallized, washed, and dried to a specified hydrate content. Finished lots are tested for identity, purity, moisture, and heavy metals before release. Because the compound can cyclize to creatinine under heat or prolonged storage in solution, manufacturers control temperature and humidity during processing. The solid itself is relatively stable when kept dry and sealed, but moisture uptake can cause caking and complicate accurate assay.
Analytical laboratories commonly identify creatine monohydrate by high-performance liquid chromatography with ultraviolet detection, often after dissolving the sample in water or dilute acid. Ion-exchange or reversed-phase columns separate creatine from creatinine and related guanidino compounds. Nitrogen content can be checked by Kjeldahl or combustion methods, while moisture is measured by Karl Fischer titration or loss on drying. These techniques give complementary views: chromatographic purity addresses related substances, whereas moisture and elemental data confirm hydrate stoichiometry. No single test defines quality by itself; a combination is used in specifications.
Storage recommendations generally emphasize a cool, dry place away from direct sunlight and strong oxidizers. Sealed containers limit humidity exchange, which helps prevent clumping and gradual conversion to creatinine. Long-term stability studies usually monitor appearance, moisture, and purity at intervals under defined temperature and humidity conditions. Accelerated tests at elevated temperature can reveal degradation pathways, but they do not perfectly predict room-temperature shelf life. Questions remain about how much creatinine formation is acceptable in different product categories and how packaging choices affect that rate over time.
Therapeutic, diagnostic and preventive monoclonal antibodies are clones of a single parent cell. When used as drugs, the International Nonproprietary Names (INNs) end in -mab. The remaining syllables of the INNs, as well as the column Source, are explained in Nomenclature of monoclonal antibodies.
Melo was chosen by the state PMDB branch to run as the vice-mayoral pick of José Fortunati, a member of the Democratic Labour Party (PDT) and a mayoral candidate in Porto Alegre in 2012. With Fortunati's victory in the first round, Melo became vice-mayor on 1 January 2013. He became an honorary citizen of Porto Alegre in 2016, through a chamber initiative.
=== First isolation and classification === Proteins were recognized as a distinct class of biological molecules in the eighteenth century by Antoine Fourcroy and others. Members of this class (called the "albuminoids", Eiweisskörper, or matières albuminoides) were recognized by their ability to coagulate or flocculate under various treatments such as heat or acid; well-known examples at the start of the nineteenth century included albumen from egg whites, blood serum albumin, fibrin, and wheat gluten. The similarity between the cooking of egg whites and the curdling of milk was recognized even in ancient times; for example, the name albumen for the egg-white protein was coined by Pliny the Elder from the Latin albus ovi (egg white). With the advice of Jöns Jakob Berzelius, the Dutch chemist Gerhardus Johannes Mulder carried out elemental analyses of common animal and plant proteins. To everyone's surprise, all proteins had nearly the same empirical formula, roughly C400H620N100O120 with individual sulfur and phosphorus atoms. Mulder published his findings in two papers (1837,1838) and hypothesized that there was one basic substance (Grundstoff) of proteins, and that it was synthesized by plants and absorbed from them by animals in digestion. Berzelius was an early proponent of this theory and proposed the name "protein" for this substance in a letter dated 10 July 1838
Perfluorobutanoic acid (PFBA) is a perfluoroalkyl carboxylic acid with the formula C3F7CO2H. As the perfluorinated derivative of butyric acid, this colourless liquid is prepared by the sequential electrofluorination and hydrolysis of butyryl fluoride.
Sources: en.wikipedia.org
Polymeric materials have widespread application due to their versatile characteristics, cost-effectiveness, and highly tailored production. The science of polymer synthesis allows for excellent control over the properties of a bulk polymer sample. However, surface interactions of polymer substrates are an essential area of study in biotechnology, nanotechnology, and in all forms of coating applications. In these cases, the surface characteristics of the polymer and material, and the resulting forces between them largely determine its utility and reliability. In biomedical applications for example, the bodily response to foreign material, and thus biocompatibility, is governed by surface interactions. In addition, surface science is integral part of the formulation, manufacturing, and application of coatings.
Tapentadol was invented at the German pharmaceutical company Grünenthal in the late 1980s led by Helmut Buschmann; the team started by analyzing the chemistry and activity of tramadol, which had been invented at the same company in 1962. Tramadol has several enantiomers, and each forms metabolites after processing in the liver. These tramadol variants have varying activities at the μ-opioid receptor, the norepinephrine transporter, and the serotonin transporter, and differing half-lives, with the metabolites having the best activity. Using tramadol as a starting point, the team aimed to discover a single molecule that minimized the serotonin activity, had strong μ-opioid receptor agonism and strong norepinephrine reuptake inhibition, and would not require metabolism to be active; the result was tapentadol. In 2003 Grünenthal partnered with two Johnson & Johnson subsidiaries, Johnson & Johnson Pharmaceutical Research and Development and Ortho-McNeil Pharmaceutical to develop and market tapentadol; Johnson & Johnson had exclusive rights to sell the drug in the US, Canada, and Japan while Grünenthal retained rights elsewhere. In 2008 tapentadol received approval by the US Food and Drug Administration; in 2009 it was classified by US Drug Enforcement Agency as a Schedule II drug, and entered the US market. Tapentadol was reported to be the "first new molecular entity of oral centrally acting analgesics" class approved in the United States in more than 25 years. In 2010 Grünenthal granted Johnson & Johnson the right to market tapentadol in about 80 additional countries.
This was Merck's first use of the designation and the reduction in regulatory risk was one of the reasons management was willing to put company resources into development. In 2013, the United States Adopted Name (USAN) name was changed from lambrolizumab to pembrolizumab. In that year clinical trial results in advanced melanoma were published in The New England Journal of Medicine. This was part of the large phase I NCT01295827 trial. In September 2014, the US Food and Drug Administration (FDA) approved pembrolizumab under the Fast Track Development Program. It is approved for use following treatment with ipilimumab, or after treatment with ipilimumab and a BRAF inhibitor in advanced melanoma patients who carry a BRAF mutation. As of 2015, the only PD-1/PD-L1 targeting drugs on the market are pembrolizumab and nivolumab. By April 2016, Merck applied for approval to market the drug in Japan and signed an agreement with Taiho Pharmaceutical to co-promote it there. In July 2015, pembrolizumab received marketing approval in the European Union. In October 2015, the US FDA approved pembrolizumab for the treatment of metastatic non-small cell lung cancer (NSCLC) in people whose tumors express PD-L1 and who have failed treatment with other chemotherapeutic agents. In July 2016, the US FDA accepted for priority review an application for recurrent or metastatic head and neck squamous cell carcinoma (HNSCC) after a platinum-based chemotherapy.
Sources: en.wikipedia.org
Sucrose is used in prepared foods (e.g., cookies and cakes), is added to commercially available ultra-processed food and beverages, and is used as a sweetener for foods (e.g., toast and cereal) and beverages (e.g., coffee and tea). Globally, on average, a person consumes about 24 kilograms (53 pounds) of sugar each year. North and South Americans consume up to 50 kg (110 lb), and Africans consume under 20 kg (44 lb). The use of added sugar in food and beverage manufacturing is a concern for elevated calorie intake, which is associated with an increased risk of several diseases, such as obesity, diabetes and cardiovascular disorders. In 2015 the World Health Organization recommended that adults and children should reduce their intake of free sugars to less than 10% of their total energy intake, encouraging a reduction to below 5%.
Nike, Inc announces it will sell "limited quantities" of a replica goalkeeper shirt worn by England goalkeeper Mary Earps during the 2023 Women's World Cup after around 150,000 people signed an online petition calling for them to be made available. A police officer is taken to hospital with critical injuries after being hit by a train while trying to help a distressed man on the railway track in Nottinghamshire. 25 August – Hartwig Fischer announces he will step down as director of the British Museum after treasures were stolen from the London institution. 26 August – Two people are killed after driving a car into a flooded road in the Mossley Hill area of Liverpool. 27 August – The Metropolitan Police launch an investigation into a possible data breach involving details about thousands of their officers after "unauthorised access" was gained to the system of one of its suppliers. 29 August – Nottinghamshire Police officer Sgt Graham Saville, 46, who was struck by a train while trying to help a distressed man on the railway track, dies in hospital from injuries sustained in the incident. London's Ultra Low Emission Zone is expanded to include the whole of Greater London. 30 August – England's Autumn 2023 flu vaccination and COVID-19 booster programme is brought forward by a month, from October to September, as scientists from the UK Health Security Agency monitor the BA.2.86 variant. Although it is not a variant of concern, it is being monitored due to its high number of mutations.
=== Protein sequencer === A protein sequenator is a machine that performs Edman degradation in an automated manner. A sample of the protein or peptide is immobilized in the reaction vessel of the protein sequenator and the Edman degradation is performed. Each cycle releases and derivatises one amino acid from the protein or peptide's N-terminus and the released amino-acid derivative is then identified by HPLC. The sequencing process is done repetitively for the whole polypeptide until the entire measurable sequence is established or for a pre-determined number of cycles.
Since about 2005, body scanners have been used primarily at airports for security (passenger) screening. Passive scanners detect the natural radiation emitted by a person's body and use it to locate objects worn or concealed on the body. Active systems also use artificial radiation to improve detection by analyzing the backscatter. A distinction is made between body scanners that use ionizing radiation (usually X-rays) and those that use non-ionizing radiation (terahertz radiation).
Sources: en.wikipedia.org
Dry, sealed creatine monohydrate can remain stable for years, but storage conditions affect its shelf life. Moisture, heat, and repeated opening of containers can reduce quality over time.
Creatine can lose a water molecule and cyclize into creatinine, especially in aqueous solution and at elevated temperatures. This is a chemical degradation process rather than microbial spoilage.
High-performance liquid chromatography is commonly used to quantify creatine and detect creatinine. Identity can be confirmed with spectroscopy or other instrumental methods.
Yes, especially when exposed to moisture or heat, where it converts to creatinine. In dry, sealed containers at room temperature, degradation is slow and the product may remain within specification for two to three years.