This is a working overview of creatinine, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-04-06. Anything still debated is marked as such rather than presented as settled.
Quality assessment of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Other methods include nuclear magnetic resonance spectroscopy, titration, and infrared spectroscopy for identity confirmation. Purity is often reported as a percentage of the labeled compound on a dry basis, while moisture content is measured separately. Because different analytical methods have different selectivity, comparing purity values across sources requires attention to the method and sample preparation.
In dry solid form, creatine monohydrate is relatively stable when protected from moisture and heat. The crystal lattice includes water, and exposure to high humidity can cause caking or gradual changes in powder flow. Elevated temperatures may accelerate decomposition, particularly if moisture is present. Studies generally report that sealed, dry material retains acceptable purity for extended periods, although exact shelf life depends on packaging and storage conditions. Light exposure is not usually considered a major factor for this compound.
In aqueous solution, creatine monohydrate undergoes a slow conversion to creatinine, a cyclized degradation product. This reaction is pH- and temperature-dependent, and it proceeds faster in warm or alkaline conditions. Because the conversion is gradual, analytical measurements of creatine in solution must account for time and storage history. The equilibrium favors creatinine more strongly at higher temperatures, which is relevant to sample handling in laboratories and to beverage formulations. Refrigeration slows but does not entirely stop this process.
In the body, creatine is synthesized from the amino acids arginine, glycine, and methionine, primarily in the liver and kidneys. It is transported to muscle and other tissues, where it is phosphorylated to phosphocreatine by creatine kinase. This phosphagen system provides a rapid source of adenosine triphosphate during short, intense contractions. Dietary creatine comes mainly from meat and fish, and the body's total pool is influenced by both synthesis and intake.
As a supplement, creatine monohydrate is studied for its effects on muscle performance and recovery. The compound is often described as an ergogenic aid, meaning it may support physical work capacity. Research typically compares it with placebo or other forms, such as citrate or nitrate, under controlled conditions. Questions remain about the optimal dose and long-term effects in different populations, and findings are not uniform across all studies. The monohydrate form remains the most extensively tested.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Cool, dry, sealed container; avoid heat |
| Relative humidity | Low; keep below about 60% | Moisture promotes caking and degradation |
| Primary degradation product | Creatinine | Forms by cyclization, especially in solution |
| Common assay method | HPLC with UV or RI detection | Separates creatine from creatinine and related impurities |
| Moisture content | Typically reported as percentage | Measured by Karl Fischer titration or loss on drying |
Solid creatine monohydrate is generally stable when kept dry and protected from extremes of heat and humidity. In the presence of moisture, it can gradually convert to creatinine, a cyclic dehydration product that has little value for phosphocreatine synthesis. Elevated temperatures and acidic conditions accelerate this conversion in solution. Because the reaction is slow in cool, dry storage, typical shelf lives are measured in years rather than weeks. Packaging that limits moisture and oxygen exposure helps maintain purity.
Recommended storage usually involves a sealed container kept at room temperature, away from direct sunlight and moisture. High humidity can cause caking, which changes flow properties and may complicate accurate weighing. Repeated opening of containers exposes the powder to air and moisture, so smaller aliquots can reduce handling effects. Storage temperature ranges are not absolute requirements; they reflect conditions that slow degradation and preserve consistent physical characteristics. Clean, dry tools help prevent contamination during sampling.
Dry creatine monohydrate is generally stable when kept sealed and protected from heat and moisture. In solution, however, creatine undergoes a slow cyclization to creatinine, a related compound with no role in phosphocreatine storage. The rate of this conversion increases with temperature and is influenced by pH. Because creatinine is a common impurity in liquid or poorly stored products, analytical testing often measures both compounds. The crystalline monohydrate is less prone to degradation than aqueous preparations, though caking can occur if moisture enters the container.
Laboratory analysis of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Detection may be ultraviolet, refractive index, or mass spectrometric, depending on the laboratory's equipment and the required sensitivity. Nuclear magnetic resonance spectroscopy can quantify the main component and identify related substances. Water content is measured by Karl Fischer titration, which is important because the monohydrate has a defined theoretical hydration level. Heavy metals, residual solvents, and microbial limits are also checked in quality control programs.
Commercial creatine monohydrate is produced mainly by chemical synthesis rather than extraction from animal tissue. Suppliers provide a certificate of analysis listing assay, water content, and impurity limits, and some products undergo third-party testing. Verification of identity can use infrared or Raman spectroscopy alongside chromatographic methods. Storage recommendations generally call for a cool, dry place and a tightly closed container to limit moisture uptake. Open questions include how packaging, flavoring agents, and long-term storage affect the stability of finished products.
Nuclear fission products are the atomic fragments left after a large atomic nucleus undergoes nuclear fission. Typically, a large nucleus like that of uranium fissions by splitting into two smaller nuclei, along with a few neutrons, the release of heat energy (kinetic energy of the nuclei), and gamma rays. The two smaller nuclei are the fission products. (See also Fission products (by element)). About 0.2% to 0.4% of fissions are ternary fissions, producing a third light nucleus such as helium-4 (90%) or tritium (7%). The fission products themselves are usually unstable and therefore radioactive. Due to being relatively neutron-rich for their atomic number, many of them quickly undergo beta decay. This releases additional energy in the form of beta particles, antineutrinos, and gamma rays. Thus, fission events normally result in beta and additional gamma radiation that begins immediately after, even though this radiation is not produced directly by the fission event itself. The produced radionuclides have varying half-lives, and therefore vary in radioactivity. For instance, strontium-89 and strontium-90 are produced in similar quantities in fission, and each nucleus decays by beta emission. But 90Sr has a 30-year half-life, and 89Sr a 50.5-day half-life. Thus in the 50.5 days it takes half the 89Sr atoms to decay, emitting the same number of beta particles as there were decays, less than 0.4% of the 90Sr atoms have decayed, emitting only 0.4% of the betas. The radioactive emission rate is highest for the shortest lived radionuclides, although they also decay the fastest.
== Contraindications == The US approval lists the thyroid C cell cancers medullary thyroid carcinoma (MTC) and multiple endocrine neoplasia type 2 (MEN 2) as contraindications because other GLP-1 agonists are known to cause such cancers in rodents. Albiglutide causes immunogenicity in rodents, so its cancer risk could not be assessed. The European approval mentions the uncertainty about C cell cancers, but not as a contraindication.
Merabishvili said that Russian troops passed the Roki Tunnel at 3:00 AM on 7 August because they couldn't be photographed in the darkness of the night. He cited Dmitry Sanakoev as having reported that Russia supplied tanks during the cloudy days so Americans would not record the movement of tanks from Russia into South Ossetia. Merabishvili said that the government had no choice: "If we lost the territory without resistance, the public society of Georgia would not forgive us." Merabishvili suggested that Georgia won time by fighting back the Russian troops and saved Tbilisi. On 25 November 2008, Erosi Kitsmarishvili, Georgia's former ambassador to Russia, gave a testimony to a parliamentary commission in which he said that Georgian authorities were preparing for the conflict. According to Kitsmarishvili, he was told by Georgian officials in April 2008 that the United States approved a war in Abkhazia, but later the Georgian authorities made the decision to launch the war in South Ossetia. According to him, "Russia was ready for this war, but the Georgian leadership started the military action first."
Six different types of vancomycin resistance are shown by enterococcus: Van-A, Van-B, Van-C, Van-D, Van-E and Van-G. The significance is that Van-A VRE is resistant to both vancomycin and teicoplanin, Van-B VRE is resistant to vancomycin but susceptible to teicoplanin, and Van-C is only partly resistant to vancomycin. The mechanism of resistance to vancomycin found in Enterococcus involves the alteration of the peptidoglycan synthesis pathway. The D-alanyl-D-lactate variation results in the loss of one hydrogen-bonding interaction (four, as opposed to five for D-alanyl-D-alanine) being possible between vancomycin and the peptide. The D-alanyl-D-serine variation causes a six-fold loss of affinity between vancomycin and the peptide, likely due to steric hindrance.
Sources: en.wikipedia.org
== External links == A primer on "Immunotherapy to Treat Cancer", NIH Immunotherapy – Using the Immune System to Treat Cancer. Archived 4 April 2017 at the Wayback Machine Cancer Research Institute – What is Cancer Immunotherapy. Archived 26 January 2017 at the Wayback Machine Association for Immunotherapy of Cancer Society for Immunotherapy of Cancer "And Then There Were Five". Economist. "Discover the Science of Immuno-Oncology". Bristol-Myers Squibb. Archived from the original on 10 October 2014. Retrieved 13 March 2014. Eggermont A, Finn O (September 2012). "Advances in immuno-oncology. Foreword". Annals of Oncology. 23 (Suppl 8): viii5. doi:10.1093/annonc/mds255. PMID 22918929. "Cancer Immunotherapy in Gujarat"
The builders of the empire planned and built impressive structures in their city centers, including canals, fountains, drainage systems and expansive irrigation. Inca's infrastructure and water supply system have been hailed as “the pinnacle of the architectural and engineering works of the Inca civilization”. Major Inca centers were chosen by experts who decided the site, its apportionment, and the basic layout of the city. In many cities we see great hydraulic engineering marvels. For example, in the city of Tipon, 3 irrigation canals diverted water from Rio Pukara to Tipon which is about 1.35 km north for Tipon's terraces. Tipon also had natural springs that they built fountains for that supplied noble residents with water for non agricultural purposes.
== History == Sodium thiopental was discovered in the early 1930s by Ernest H. Volwiler and Donalee L. Tabern, working for Abbott Laboratories. It was first used in human beings on March 8, 1934, by Dr. Ralph M. Waters in an investigation of its properties, which were short-term anesthesia and surprisingly little analgesia. Three months later, Dr. John S. Lundy started a clinical trial of thiopental at the Mayo Clinic at the request of Abbott. Abbott continued to make the drug until 2004, when it spun off its hospital-products division as Hospira. Thiopental is famously associated with a number of anesthetic deaths in victims of the attack on Pearl Harbor. These deaths, relatively soon after the drug's introduction, were said to be due to excessive doses given to shocked trauma patients. However, evidence available through the freedom of information legislation suggested that the story was exaggerated. Of the 344 wounded that were admitted to the Tripler Army Hospital, only 13 did not survive, and it is unlikely that thiopentone overdose was responsible for more than a few of them.
Sources: en.wikipedia.org
Dry, sealed creatine monohydrate can remain stable for years, but storage conditions affect its shelf life. Moisture, heat, and repeated opening of containers can reduce quality over time.
Creatine can lose a water molecule and cyclize into creatinine, especially in aqueous solution and at elevated temperatures. This is a chemical degradation process rather than microbial spoilage.
High-performance liquid chromatography is commonly used to quantify creatine and detect creatinine. Identity can be confirmed with spectroscopy or other instrumental methods.
It is a compound made of creatine bound to one water molecule. It appears as a white crystalline powder and is the most common solid form of creatine used in research and supplements.